CTM HS-268, Service Manual

Page: 57 / 68

55
SERVICE - 12 - 2
Remote Control Board Repair
Remote Control Board Repair :
Please carry out the
SERVICE-12-1 Micro Switch Repair steps for removal, then :
1.Locate the waterproof cover of the remote control board inside the rear lower cover.
2.Remove the four screws on the cover.
3.Take the cover off to expose the remote control board.
※
When reinstalling, please carry out these steps in the exact reverse sequence.
※
For relevant operations of the remote control board, please refer to the following
“Remote Controller Setting”.
Remote Control External Frequency Pairing Setting :
Unfold the scooter and equip with battery pack.
1.Turn on the main power switch, and unlock the scooter.
2.Long-press the folding and unfolding buttons at the same time for 2 seconds. The
board indicator (orange light) comes on to indicate it is ready for setup.
3.Press either the folding or unfolding button once of the remote control and the light
indicator will flash. When the indicator stops flashing, setting is complete. A maximum
of four remote controls can be set up on the same unit of scooter.
4.Turn off the main power switch.
5.Press the folding / unfolding button to check if the setting has been successful. Repeat
the setting if the scooter does not fold.
※
Step 2.In the setting state, a long press of 5 seconds, on either the folding or unfolding
button, will erase all remote control settings. After an erase the board indicator light will turn off.
※
If this does not work, go to “Remote Controller Internal Setting” on next page.