CTM HS-268, Service Manual

Page: 51 / 68

49
15+-2kgf-cm
SERVICE - 11 - 1
DR Controller Repair
•
The connectors underneath the rear top cover can be checked without
removing the cover. Refer to Step 5 of SERVICE-11 Rear Top Cover
Repair, to ensure the connections are made (for connector instructions,
please refer to the above connector codes).
Picture showing rear top cover circuit connectors.
Rear top cover - folding board control connector
Rear top cover - taillight connector
Rear top cover - battery power connector
Remote control board - folding suppression connector
Main cable connector
Micro switch connector
Electromagnetic brake connector
Motor power connector
Linear actuator - power connector
Remote control board - power connector
※
If the connections are good (the wires are undamaged and not loose), but the action
still fails, refer to the following DR Controller Replacement.
DR Controller Replacement :
Please refer to SERVICE-11 Rear Top Cover Repair for removal, then perform :
1.Unplug all the connectors on the controller.
2.Remove the two screws on the DR controller to separate it from the frame.
3.Take the DR controller out.
※
When reassembling, please follow the exact reverse sequence of these steps.
※
After re-installation check to make sure all the connections are correct and secure.