•
•
CSS Laboratories
Section 2 – Using the SBP-205
•
10
Recommended Memory Configuration
The following table displays the recommended system memory configuration,
starting at 64 MB.
SBP-205 System Memory Configuration
RAM
Bank 0
Bank 1
RAM
Bank 0
Bank 1
64 MB
8M x 64/72
256 MB
32M x 64/72
128 MB
8M x 64/72
8M x 64/72
320 MB
32M x 64/72
8M x 64/72
128 MB
16M x 64/72
384 MB
16M x 64/72
32M x 64/72
192 MB
16M x 64/72
8M x 64/72
512 MB
32M x 64/72
32M x 64/72
256 MB
16M x 64/72
16M x 64/72
Installing and Removing Memory
The SBP-205 DIMM sockets are located on the left side of the board.
IMPORTANT NOTE
:
It should not be necessary to remove the single board
computer from the passive backplane or the system chassis in order to remove or
install memory modules. However, it is very important to properly support the board
while applying pressure during DIMM removal or installation. On-board circuits,
connectors or the board itself could be damaged if not properly supported.
Ground or discharge any static electricity before making hardware modifications.
Figure 3 – SBP-205 DIMM Sockets
Follow these steps to install or remove memory modules:
1.
Power down the system and remove the power cord.
2.
Open the system case following the steps in the User Guide provided
with your MaxPro or ProRack system.
3.
Locate the DIMM sockets on the SBP-205.
DIMM Sockets
Locking Clips
Locking Clips
