Crivit 292218, Instructions For Use Manual

Page: 16 / 22

18 GB
Use and Installation
Instructions
Snap-Fastener System (Fig. B)
The snap-fastener enables an individual and
quick vernier adjustment of the chin strap.
Press the snap-fastener together until the helmet
is sitting comfortably but firm.
The movable buckle may be used to fasten or
secure excess chin strap.
Ear pad (Fig. C)
The ear pads (3) are secured to the helmet
with two press studs. The pads may simply
be pulled out.
You must hear each press stud lock when secur-
ing the ear pads inside the helmet.
Acoustic Damping (Fig. D)
The acoustic damping (4) is for noise reduction,
in particular when driving at high speeds.
Press the acoustic damping into the cavity of the
cheek pads. The acoustic side pad equipped
with Velcro faces towards the helmet shell.
Visor Replacement (Fig. E)
Removing the visor
Press and turn the cover plate (1a) on both
sides counter-clockwise to release. Remover the
inner (1a) and outer cover plate (1b) and remove
the visor (1c).
Installing the visor
Position the visor on the visor holder (1d) and
place the outer cover plate over the visor.
Note: Be sure to attach the outer cover plate
labelled “L” to the left side of the helmet.
Attach the inner cover plate to the outer cover
plate and secure the visor by simultaneously
pressing and turning clockwise.
Selecting the correct
helmet size
• Measure the circumference of your head and
select the helmet size based on this measure-
ment. Try out several helmets before deciding.
Ideally, the skin on your temples will move
along when wearing the helmet.
• Ensure that even without the chin strap secured,
the helmet does not move much on your head.
• The chin strap must be closed firmly for a
secure fit. It is fitted correctly if it is difficult
to slide your fingers under the chin strap.
However, you must still be able to comfortably
breathe, swallow and turn your head.
• Verify the helmet was tested according to the
latest ECE standard.
Maintenance and Care
Regular maintenance and care contributes to
safety and maintaining the helmet.
Cleaning of the Helmet
• Never use solvents, petrol or other detergents
when cleaning the shell and interior of your
helmet.
• Always use pH-neutral detergent dissolved
in clean water. Careful rub with a soft cloth.
Then wipe dry with a lint-free cloth.
Visor care and cleaning
• After using the helmet, lightly wipe off any
grime (e.g. dead insects, dirt, sand, dust etc.)
from the visor with a soft cloth and then fully
wipe it clean using a dry soft cloth.
• When the visor gets wet (e.g. rainwater) it
should always be wiped with a soft cloth.
• When cleaning the visor, never use any petrole-
um-based solvents or detergents containing
abrasives.
Size table
Size Head circumference
S 55–56cm
M 57–58cm
L 59–60cm