Crane 93941, User Manual

Page: 11 / 48

Checking the stepper and pack contents
11
− The loops of the stepper are only designed for upward
tensile load. Do not subject the loops to horizontal stress.
Checking the stepper and pack contents
NOTICE!
Risk of damage!
If you are not cautious when opening the packaging with a sharp
knife or other pointed object, you may quickly damage the stepper.
− Be very careful when opening.
1. Take the stepper out of the packaging.
2. Check to make sure that the delivery is complete (see
fig. A
).
3. Check whether the stepper or the individual parts exhibit damage. If this
is the case, do not use the stepper. Contact the manufacturer at the service
address specified on the warranty card.
Assembly
For the most part, the stepper is preassembled. You will need the enclosed Philips-
head screwdriver 8 to complete the last assembly steps.
Make sure there is enough unobstructed room. There should be at
least 2 feet (0.6 m) of unobstructed space around the workout area
(see fig. B ).
1. Insert the two plastic feet 6 in the frame tube 5 (see fig. C ). The bearing
surface of the plastic feet must be pointing down at the end.
2. Screw each Philips-head screw 7 into the predrilled hole on the bottom of
the frame tube.
3. Screw the adjustment screw 12 into the threading on the front housing 13
(see
fig. D
).
Workout preparation
Attaching the carabiner clip
You can work out on the stepper with or without the resistance band 2 .
To work out with the resistance band, proceed as follows:
− Screw the carabiner clip 4 of the resistance band loose.
− Attach the carabiner clip to the loop 11 on the stepper and screw the cara-
biner clip back into a closed position (see
fig. E
).
ZUR
FREIGABE
V7