Crane Merchandising Systems Genesis, Technical Manual

Page: 90 / 128

outlet adaptor from the coffee brewer. Pull down the spring loaded brewer
release pin and carefully remove the brewer unit from its locating bracket.
2. Removing The Filter Mesh Assemblies
Both the coffee brewer and tea brewer contain fine screen mesh assemblies which
ensure coffee and tea vends are produced to the highest standards.To remove the mesh
assemblies, proceed as follows:
1. Remove the brewer unit from the machine as previously described and place on
a flat surface. Lift the latch bar and remove the brewer chambers/wipe arms
assembly.
2. Removing the coffee filter mesh: Using the coffee filter extractor tool, part
no. ME10385000, insert the tool into the output spout of the coffee brewer
chamber with the tip pointing upwards.
3. With the tool to the rear of the chamber, gently push up on the rear of the filter
assembly to unseat it. Remove the filter assembly from the brewer.
4. Removing the tea filter mesh: Using a small flat bladed screwdriver or similar,
insert the tool up through the tea outlet and carefully push the filter assembly up
and out of its location.
5. If necessary, soak the filter mesh assemblies in a correctly diluted cleaning solution
for a maximum of 30 minutes. Rinse the filters with clean water before refitting
to the brewer unit.
6. Replacement filters are available from the manufacturer.
Coffee Filter - Part No. PL07155000
Tea Filter - Part No. ME1038000
3. Refitting The Filter Mesh Assemblies
The following description applies to both the coffee and tea filter assemblies.
1. Ensuring that the gauze screen is to the top, align the filter assembly with its
locating position above the brewer chamber. Ensure that the locating lip on the
filter assembly lines up with its corresponding slot in the chamber.
2. Push down on the filter assembly to secure it in its locating position.
88
Technical Manual