![background image](http://html1.mh-extra.com/html/cpi/t04co/t04co_installation-and-operation-manual_2675030030.webp)
I N S T A L L A T I O N
2.4.7 RF Output Waveguide Flange Connection (J8)
The output waveguide flange of the MPA Hub Mount is located on
the rear panel (Figure 2-3). The mating connection is either a WR
137 (C) or WR-75 (Ku) flat wave guide flange with four through
holes (6-32 clearances). An O-ring gasket is supplied in the ship kit.
To install the waveguide flange, proceed as follows:
a.
Install the O-ring gasket (supplied) in the output flange of the
MPA Hub Mount
b.
Position the interconnecting waveguide so that it aligns
precisely with the waveguide flange at the rear of the MPA
Hub Mount.
Figure 2-3. MPA Hub-Mount Rear Panel
CAUTION!
If flange alignment is not precise or if the installation is
subject to motion or severe vibration, a flexible waveguide section
should be installed between the output of the MPA Hub Mount and the
interconnecting waveguide.
2-8
Installation and Operation Manual
Summary of Contents for T04CO
Page 41: ...M P A H U B M O U N T Figure 3 5 Remote Control Unit Menu Tree Doc 01031254 Rev 1 3 9 ...
Page 68: ...O P E R A T I O N 5 10 Installation and Operation Manual This page intentionally left blank ...
Page 74: ...D R A W I N G S 7 2 Installation and Operation Manual This page is intentionally left blank ...