Country Clipper CBS2, Operator'S Manual, Page: 5 / 30

5
Your grass collection system has been designed to give
you a low maintenance, simple, and effective way to
collect the grass clippings from your mower. This manual
is provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
NOTE: all references made to right, left, front, rear, top
or bottom are as viewed from the normal operator’s
position on the mower.
1-2 Description
1-1 Introduction
The grass collection system is designed for turf
maintenance where there is a need to collect the grass
clippings as the mower cuts the turf. It is also used for
picking up leaves and twigs in pre-season and post-
season clean-up.The blower, mounted on the right side
of the unit, uses a belt and gearbox system from the
engine PTO shaft. Drive train protection comes through
belt slippage. The blower draws grass clippings from the
discharge area of the cutter deck back to the (3) - 4.0
cubic foot collection bags P#(G0003) at the rear portion
of the mower frame. The operator can engage the blower
with a push of the over-center linkage on the right side of
the unit. Once the bags are full with clippings, they can
be released to make for easy dumping.
Section II - Installation For Use
Remove deck drive belt from the clutch pulley (refer to
your Country Clipper operator’s manual). From the
underside of the engine, disconnect the wiring harness
attached to the electric clutch. Remove the bolt and
electric clutch from the mower. Next, remove the D-drive
spacer using an arbor press or equivalent. On removal,
adjacent bearing OUTER race must be supported or
bearing damage may occur. Refer to Figure 2-1a.
2-1 Preparation Of Mower
SECTION I - INTRODUCTION AND DESCRIPTION
Once the Engine Pulley Bushing P#(S0191) is installed,
reattach the clutch assembly to the mower and then
review Figure 2-1c. To assemble and fasten the Engine
Pulley, align Pulley hole to the Engine Pulley Bushing
and fasten using (1) Clamp Washer P#(K0278), (1)
7/16” lock washer P#(K0140), and 7/16”-20 x 3-1/2” hex
bolt P#(K0550). Torque the bolt to 55 ft./lbs. The added
pulley will power the collection system and should
resemble Figure 2-1d when installed.
The engine pulley bushing must be installed using an
arbor press or equivalent. Upon Installation, opposite
bearing inner race must be supported or bearing
damage may occur. Refer to Figure 2-1b.
PRESS
Figure 2-1a
PRESS
Figure 2-1b
Engine Pulley Bushing Installation
Electric Clutch
Figure 2-1d
Engine Pulley
Bushing
Hex Bolt
Lock Washer
Pulley
Bushing
Number
Located
Here
Figure 2-1c
Use M0266 (4.25” OD) For Charger Mowers
Use M0309 (4.75” OD) For Challenger Mowers
Clamp Washer
Pulley
Engine Pulley Assembled Into Electric Clutch