Country Clipper CBS2, Operator'S Manual, Page: 15 / 30

15
Installation
2-18 Lower Hose To Blower Cone
Slide a hose clamp P#(J0080) over both ends of
the lower hose. Then proceed to slide the lower hose
onto the blower cone. Tighten the hose clamp. Refer to
Figure 2-19.
Take the unattached end of the lower hose and slide it
clamp to secure the hose to the boot (Figure 2-19). Tip:
Before securing clamp rotate hose counter-clockwise
boot to mower deck.
(away from yourself) approximately 1” to aid in retaining
2-19 Lower Hose To Boot Installation
over the circular end of the boot. Use the lower hose
(Figure 2-19) for details. Make sure both ends of the
assembly inlet. Tighten the hose clamps.
blower assembly, and the deck boot.
adjust for the blower assembly’s movement as well as
hoses until you have tried to fit them on your machine.
allow for enough clamping surface between the inlet,
end of the 6” hose onto the inlet. Make sure there is
Slide a pre-assembled hose clamp P#(J0060) onto both
2-16 Length Of Hose Adjustment
2-17 Upper Hose Installation
about a two-inch overlap between the hose end and the
the inside of the top to the outside and lock into place.
The hoses in steps 2-17 and 2-18 must be cut to fit your
Remember that the hoses have to be long enough to
ends of the 6” upper hose (Figure 2-19). Then slide one
container inlet. Proceed to slide the opposite end of the
6” hose onto the outlet of the blower assembly. See
Fasten the inlet to the plastic top by sliding the inlet from
machine. Follow steps 2-17 and 2-18. Do not cut the
hose are clearly attached to the inlet and the blower
Figure 2-19
Inlet
Hose
Clamps
Hose
Clamps
Boot
Lower
Hose
Blower
Outlet
Upper
Hose
Blower
Cone