Country Clipper CBS2, Operator'S Manual, Page: 14 / 30

14
Secure the boot plate P#(B0820) to the aluminum boot
P#(E1902) using (2) 3/8”-16 x 1” carriage bolts
P#(K1182) and (2) 3/8”-16 nylon flange locknuts
P#(K2038). Insert the carriage bolts from the inside of
the boot so the threads are on the top of the boot. This
will prevent grass clippings from collecting on the
threads. Leave the hardware loose until the boot plate
has been attached to the mower deck.
Refer to Figure 2-14a and 2-14b for Challenger Mowers
or 2-14c for Charger Mowers.
2-14 Boot Plate Installation 2-15 Boot To Mower Deck Installation
Remove the hardware from the grass deflector and
insert (1) boot rod P#(B4331) into the grass deflector
mounting holes as shown in Figure 2-14a. Secure the
boot rod using (1) hair pin clip P#(K0099). With the
carriage bolts from Section 2-14 still loose, adjust the
position of the boot so that there is no gap between the
mower deck and the boot. Tighten the hardware at this
time.
Boot Rod
(2) 3/8”-16 x 1”
Carriage Bolts
(2) 3/8”-16
Locknuts
Boot Plate
Aluminum
Boot
Hair Pin
Clip
Figure 2-14a
Figure 2-14c
Charger
Mounting Holes
Figure 2-14b
Challenger
Mounting Holes