Installing the holsters and cable assemblies
3-5
Step 4 - Install cable assembly 2
Insert cable assembly 2 into the main
body’s access panel opening, then
slide it into the body all the way until it
is flush with the top of the bottom front
panel.
IMPORTANT NOTES:
• When sliding the cable assembly
into the body, ensure that the serial
cable that hangs down from the
topmost terminal block does not
get caught between the cable
assembly and the bottom terminal
block. It should be held in place by
the clip, as illustrated.
• Ensure the cable assembly is fully
seated and that there is no gap
between the bottom of the cable
assembly and the top of the front
panel. The cable assembly fits
tightly and may require extra
downward force to ensure it is fully
seated.
Ensure this cable is
held in place by the
retaining clip to
prevent it from
being caught when
you slide the cable
assembly down into
the body
