ENGLISH
23
6/2014 - Rev. 00
3 - Press towards to center the plastic diffuser, to remove the lip of the upper guide. Doing this in the
whole length of the piece.
4 - Disassemble diffuser lower guide, and pull out to remove.
5 - Place the lamps; take carefully with both hands (near end) and turn to release them from their
sockets. Extract down.
Note: Respect the value of maximum power lamp is marked with stickers on the profile.
6 - For replacement, match terminals caps in the notch of the sockets on both ends. With both hands
near the ends of the lamp, turn until the system locks. Ensure correct installation by a soft down effort.
7 - Put the diffuser along the entire lower guide. Hold with one hand and with the other take the upper
lip to the upper guide.
8 - Press the entire length to ensure that the fit is right along the whole profile.
9 - Connect the lighting circuit to the mains and test its performance.
10. ABNORMAL OPERATING CONDITIONS
1) The cabinet will not start or stops:
• Check that there is a power outage;
• Check that the main switch is turned on;
• Check that the cabinet plugs are connected properly.
If power failure is not due to the above reasons, immediately call the nearest service center and drain
completely counter immediately storing products in freezers or refrigerators to ensure their
preservation temperature.
2) The cabinet does not chill sufficiently:
• Check that the sliding windows are not open or half open. After having closed well, the red alarm
light will turn off when the temperature set is reached.
1
2
