60T - 280T
COSMOGAS
17 - MAINTENANCE
17.8 - Connecting the Display
to the other burners
In 100T to 280T appliances, being multi-burners, the display
in figure 16-1 is always connected directly to “Burner 1
(Master)”. All the parameters that can be consulted on the
display (sections 16.14, 16.15 and 19) that refer to Burner 1
(Master) exclusively concern this burner. If you wish to see/
change the same parameters for the other burners, you must
move the display connection from “Burner 1 (Master)” to the
burner you wish you view/edit; proceed as follows:
(refer to figure 17-10):
1. Disconnect power to the appliance;
Figure 17-10 Connecting the display in the other burners
A = Connector for Burner 1 (Master) dialogue
B = Connector from display
C = Connector for Burner 2 dialogue
D = Connector for Burner 3 dialogue (Only in 180T, 210T and 280T models)
E = Connector for Burner 4 dialogue (Only in 280T models)
2. Follow what is described in section 17.2 to access the inner
components;
3. Disconnect terminal “B” (coming from the display) from
terminal “A” (coming from “Burner 1 (Master)”);
4. Connect terminal “B” to terminal “C”, “D” or “E”, depending
on which burner you wish to view or edit, considering that:
terminal “C” is for “Burner 2”; terminal “D” is for “Burner 3”
and terminal “E” is for “Burner 4”
5. Once the terminal is connected to the burner to be checked,
repower the appliance and switch it on;
6. The display will now show all the information regarding the
connected burner. Make all consultations or modifications
following what is described in sections 16.14, 16.15 and 19.
7. Once the check is complete, reconnect terminal “B” to
terminal “A” as it was previously.
Burner 2
Burner 1
(Master)
Burner 3
Burner 4