CORRECT CRAFT 200-CB, Owner'S Manual

Page: 77 / 210

4-8
Section 4
Control Switches
Each electrical circuit on your boat is equipped with a control
switch. The switches have an indicator light for easy ON/OFF
identification. All switches are fuse protected.
If a short is detected, the associated LED will flash on the
buttonpad. To reset the circuit, turn off the offending load, stop the
engine, then hold the STOP button for a couple of seconds until
the flashing stops. For PDM-driven loads, or loads like the HORN
that do not have a dedicated LED, the backlights flash instead.
Engine Compartment/Bilge Area Blower
The “BLOWER” switch activates the engine compartment
ventilation blower to remove explosive fumes from the area. The
blower is turned on by pressing and releasing the “BLOWER”
switch. Press again to turn off. The blower must be operated for a
minimum of four minutes each time before starting the engines or
generator. In addition, the blower should be operated continuously
when at idle or running at slow speeds.
Explosion and fire hazard from gasoline
vapors can cause death or serious injury from failure to
check for fumes in the engine compartment or operating
the blower. Before engine start-up, check engine
compartment for gasoline vapors, then operate blower
for at least four minutes. Operate blower whenever
below planing speed.
!
The intakes which supply fresh air into
the bilge area are located near the floor in the port and
starboard aft storage compartments. The intakes must
remain clear to allow air to enter the bilge area. DO NOT
drape towels or any items which may not allow air to be
drawn in while the bilge blowers are operating.
!
D-Drive Sec 4_2013_Nautique Ski Sec 4.qxd 7/3/12 10:15 AM Page 8