1
91678
SAFETY PRECAUTIONS
This ice dispenser has been specifically designed to provide protection against personal injury and eliminates
contamination of ice. To insure continued protection and sanitation, observe the following
Always
disconnect power to the dispenser before servicing or cleaning.
Never
place hands inside of hopper or gate area without disconnecting power to the dispenser. Agitator rotation
occurs automatically when the dispenser is energized!
ALWAYS
be sure the removable lid is properly installed to prevent unautho-
rized access to the hopper interior and possible contamination of ice.
ALWAYS
be sure the upper and lower front panels are securely fastened.
ALWAYS
keep area around the dispenser clean of ice cubes.
CAUTION: Dispenser cannot be used with crushed or flaked ice.
Use of bagged ice which has frozen into large chunks can void warranty. The dispenser
agitator is not designed to be an ice crusher. Use of large chunks of ice which “jam up”
inside the hopper will cause failure of the agitator motor and damage to the hopper. If bagged ice
is used, it must be carefully and completely broken into small, cube-sized pieces before filling into
the dispenser hopper.
GENERAL DESCRIPTION
The Remcor TJ200 and TJ300 series of ice dispensers solve your ice service needs the sanitary, space saving,
economical way. Designed to be manually filled with ice from any remote ice making source, or to be used with
one of several “piped ice” type ice makers or top-mounted “Ice cuber,”
These dispensers will dispense cubes (up 1-3/8” in size), cubelets, hard-chipped or cracked ice. Remcor dis-
pensers cannot be used with crushed or flaked ice.
“B” models contain beverage faucets only and must be supplied with cold product from any remote cold plate or
refrigerated soda factory.
“BC” models contain beverage faucets and an internal cold plate system. They are designed to be supplied di-
rect from syrup tanks and carbonator, with no additional cooling required.
The TJ250 with 19” x 28” cold plate is shipped with sink not installed. After beverage hook-up is complete, sink
is to be positioned with cabinet side flange slots and push sink in. Install side mounting pins to retain sink. Make
sure all drain connections are complete.
