5
91678
OPERATING INSTRUCTION
1. Ice Dispensing: Depressing the operating lever activates a micro switch behind the front panel which ener-
gizes the agitator motor and gate solenoid. This causes the agitator to rotate and the gate slide to lift, al-
lowing ice to push out the gate opening.
2. Ice level (Standard Models): When ice level light is on, remove the lid and fill the hopper with ice. Replace
lid to avoid contamination of ice.
CAUTION: Use caution to avoid spilling ice when filling dispenser. Clean up immediately
any spilled ice from filling or operating the unit. To prevent contamination of ice, the lid
must be stalled on the unit at all times.
Automatic Ice Filling (“A” models): While the ice maker is running, the ice entering the hopper from the feed
tube should be loose and in small pieces. Ice entering in the form of hard-packed cylinders indicates a re-
striction or distortion of the feed tube and could result in ice maker malfunction, if not corrected. The auto-
matic agitation timer causes the ice to level which allows the entire storage bin to fill before the ice machine
shuts off. When the ice level remains at the deflector after agitation, the ice maker control capillary (ice
maker bulb) stops ice maker operation until the level drops and the bulbs warm up.
Immediately after ice maker shut-off, observe the ice in the hopper between the feed tube entrance and the
deflector. it should be loosely pressed against the top of the deflector, indicating correct thermostat opera-
tion. If the ice level is low or if the ice is packed hard against the deflector, it will be necessary to re-adjust
the ice maker bin control, according to the ice maker instructions. Adjust the control warmer to lower the
ice level and colder to raise the ice level.
Automatic Ice Filling (“K” Models): As the “A” models, the agitation tier causes the ice to level which allows
the entire storage bin to fill before the ice machine shuts off. The ice maker control capillary bulb maintains
the ice level in the storage hopper. Consult the instructions provided with the installation kit and the ice
maker manual for location and operation of the ice maker control.
Beverage System - Beverages may be dispensed by operating the lever on the appropriate faucets. On
units with cold plates (“c” models), periodic movement of the ice in the hopper is necessary to maintain the
level of ice on the cold plate. On initial start-up or after long idle perios with no use, dispensing ice for 20-30
seconds is necessary to fill the cold plate or warm beverages may be experienced.
