Use and Maintenance Manual – 08/2018 Rel. 4
Page 27
12
At the end of the spin, the MOTO
wheel type calibration is finished
and the machine will switch to
NORMAL mode, ready to run the
balancing.
13
To exit at any time the calibration
procedure during its progress,
press on icon.
The MOTO wheel type and the
ALU1 Program Type will remain
set and the wheel dimensions will
be those which were
automatically set by the machine
for this kind of calibration.
If you have anomalies during the calibration procedure, the machine will display the error message (for example
ERR 025
). See
chapter
“20. Error codes”
to solve the problem and continue/repeat/cancel the calibration in progress. Launches that are interrupted
by lifting the wheel guard can be repeated by lowering the wheel guard back down.
16. USE OF THE MACHINE IN NORMAL MODE
To use the machine, you must select or set as follows:
•
Program Type (program for wheels with steel, aluminum or special aluminum rim). Default = program for wheels with steel
rims;
•
Wheel type (auto-vehicle, motorbike, off-road). Default = auto-vehicle;
•
Dimensions of the wheel to balance. The dimensions can be fully entered automatically;
•
Dynamic or Static balancing. Default = Dynamic;
•
Display resolution X1 or X5. Default = X5.
The selections described above can be entered before or after the spin. For any variation of the selection or data settings, the machine
will run a calculation by displaying the new values of imbalance.
When the required selections/settings have been made it is possible to perform a launch by lowering the wheel guard. At the end of
the spin, the machine displays the wheel imbalance values.
