Installation for indoor unit
65
USER'S MANUAL
Dimension drawing of indoor unit installation
1.
The wall for installation of the indoor unit
shall be hard and firm, so as to prevent
vibration.
2.
Use the "+" type screw to fasten the peg
board, horizontally mount the peg board
on the wall, and ensure the lateral
horizontal and longitudinal vertical.
3.
Pull the peg board by hand after the
installation, to confirm whether it is solid
1.
Make a hole with an electric hammer or a water
drill at the predetermined position on the wall for
piping, which shall slant outwardly by 5°-10°.
2.
To protect the piping and the cables from being
damaged running through the wall, and from the
rodents that may inhabit in the hollow wall, a pipe
protecting ring shall be installed and sealed with putty
Note :
Usually, the wall hole is Φ60mm~Φ80mm.
Avoid pre-buried power wire and hard wall when
making the hole.
Mounting plate
Wall-through Hole
Space to the ceiling
15cm above
230-260cm
Space to the floor
20cm above
20cm above
Space to the wall
Space to the wall
Pipe
protection
ring
Putty
