![CoolBot Walk-in Cooler Construction Manual Download Page 30](http://html.mh-extra.com/html/coolbot/walk-in-cooler/walk-in-cooler_construction-manual_2660815030.webp)
PHONE: 888-871-5723
2018 © Store It Cold, LLC.
Rev 2018-9a
All Rights Reserved.
OPERATION AND MAINTENACE INSTRUCTIONS
1.
OPERATION
•
Product inside your walk-in cooler should not be overloaded or tightly stacked as to
inhibit proper air flow and air distribution throughout the box.
•
DO NOT STACK PRODUCT INFRONT OF THE A/C.
The top of the box is not designed for storage. Items stored on top may cause
condensation, damage panels and void the warranty.
2.
ROUTINE CLEANING
•
Wipe panels with a damp cloth using mild soap. DO NOT use harsh chemicals or
abrasive pads or cleaners. Stainless should be cleaned with stainless steel cleaner;
wipe in the direction of the grain. Dry all finishes thoroughly.
•
Clean door gaskets using mild soap; wipe dry after cleaning
•
Do not wash down or spray the inside of the walk-in with water
•
Clean the fins of your A/C following the instructions on page 15 ( DIRTY FINS ) of
your COOLBOT INSTRUCTIONS MANUAL AND TROUBLESHOOTING GUIDE.
3.
PERIODIC INSPECTIONS
•
Inspect the door gasket for wear and make sure it seals tight against the Stainless-
Steel trim of the frame. Replace gaskets if worn or torn.
•
Inspect the hydraulic door closer to ensure that it engages when the door is within
an inch or two and pulls the door tight.
•
Inspect the door hinges and lubricate hinge pins with petroleum jelly as needed.
•
Inspect the door sweep gasket at the bottom of the door for proper seal. Replace if
sweep is worn or torn.
•
Check the Thermometer reading with another thermometer in the same location or
by placing the thermometer probe in to a cup of water with ice; it should read 32°F
(0°C).
•
Check for missing plugs and buttons and replace as necessary.