C24AB
9
OPERATING CONTROLS
FOR DELTA TILLER
SECTION 7
1. KEY SWITCH - Insert the key and turn it clockwise one-quarter turn to turn on power.
The Battery Level Meter will move only when the key switch is on.
2. BATTERY LEVEL METER - This shows how much power is left in the batteries. The
batteries are charged when the needle is on the right hand side of the green area, and
low when it is in the red area.
NOTE:
Battery condition should be checked when the Solo XT550 is stopped. While
operating, the needle will read lower.
3. HORN - Push button to sound horn.
4. VARIABLE SPEED SELECTOR - This controls the maximum speed you can travel.
Rotate the knob clockwise for higher speeds and counterclockwise for lower speeds.
Operate your Solo XT550 at lower speeds until you are familiar with how it handles.
Always use lower settings in confined or crowded areas. Faster speeds should not be
used except when traveling straight and in open areas.
NOTE:
Reducing the speed setting also reduces power. If you are unable to climb a
ramp, you may need to turn the knob clockwise to increase power.
WARNING
Operating too fast for conditions can cause the Solo XT550 to tip over. This may
result in serious injury to yourself and damage to your Solo XT550. ALWAYS
REDUCE SPEED BEFORE TURNING AND WHILE OPERATING ON UNEVEN
SURFACES.
Figure 10
6
4
3
5
2
1
7
WARNING
Accidentally bumping the Accelerator Lever while the key switch is on will cause the
Solo XT550 to move out of control. This may result in an accident, causing serious
injury or property damage. Do not turn the key switch on until you are securely
seated on the Solo XT550. ALWAYS TURN THE KEY OFF WHENEVER YOU ARE NOT
DRIVING THE SOLO XT550, EVEN IF YOU ARE SITTING IN THE SEAT. ALWAYS BE
SURE THE KEY IS REMOVED WHEN YOU ARE NOT SEATED ON THE SOLO XT550
TO PREVENT UNAUTHORIZED USE OR ACCIDENTAL MOVEMENT.
