C24AB
12
BRAKE SYSTEMS
SECTION 9
Your Solo XT550 uses two systems for braking, both of which are designed for automatic
operation. When you release the Accelerator Lever, the DYNAMIC BRAKE quickly and
safely brings you to a stop. After you are stopped the PARKING BRAKE automatically
comes on to keep the Solo XT550
from rolling. The PARKING
BRAKE also helps to stop you
when operating on a ramp or
incline.
The PARKING BRAKE is
engaged by spring pressure. It is
automatically released by an
electromagnet whenever you
move the Accelerator Lever. In
the event of a malfunction which
causes a loss of power, the
PARKING BRAKE will
automatically engage. A
MANUAL RELEASE LEVER is
provided which will release the
brake and allow the Solo XT550 to
be pushed. Simply pull up on the
lever (fig 14) to release the brake.
Push down to operate the Solo XT550.
When the MANUAL RELEASE LEVER is in the “released” position, a safety interlock
switch prevents the Solo XT550 from being driven. Do not leave the brake lever in the
“released” position when the Solo XT550 is unattended. A small amount of current is
required to power the interlock relay (
even with the key switch off
) which could eventually
drain the batteries.
WARNING
Never attempt to operate the Solo XT550 with the MANUAL RELEASE LEVER in the
“released” position. If the safety interlock is not functioning, you will be driving the
Solo XT550 with no PARKING BRAKE. This could result in an accident if operating
on a ramp or incline, causing serious injury and damage to property. Always be sure
the manual release lever is in the “drive” position before operating the Solo XT550.
Figure 14