EMS-96
Instruction Manual
IM1200-U v1.6
Pag. 5 / 48
Installation
Warning for the user
Read carefully the instructions/indications contained in this manual before installing and using the instrument.
The instrument described in this manual is intended for use by properly trained staff only.
Safety
This device has been manufactured and tested in compliance with EN 61010-2 standards. In order to maintain these conditions
and to ensure safe operation, it need to comply with the indications and markings contained in the manual.
When the device is received, before beginning installation, check that it's O.K. And it has not suffered any damage during
transport.
When starting installation make sure that the operating voltage and mains voltage are compatible with the device instructions.
The device power supply must not be earthed.
Maintenance and/or repair must be carried out only by qualified and authorized personnel. If there is ever the suspicious that,
that there is a lack of safety, during operation, the device must be disconnected and cautions taken against accidental use.
Operation is no longer safe when:
- The instrument doesn't work.
- The measured value are obviously wrong or unreasonable.
- There is visible damage.
- After serious damage incurred during transport.
- After a storage under unfavourable conditions.
During normal operation of the devices, hazardous voltages at its terminals and in particular on the terminals of voltage and
current transformers connected and on the terminals of the digital input and outputs.
The secondary circuits of the voltage and current transformers are capable of generating hazardous voltages and currents when
their primary circuit is powered.
Follow the standard safety precautions when performing any installation or service (such as making sure that the power supply
is disconnected, disconnecting the fuses of the transformer voltages, short-circuiting the secondary of current transformers
etc.).
Don’t use the instrument when failure may cause injury or death, or generate sufficient energy to cause a fire.
The instrument is equipped with a fuse on the power supply type: 5x20mm 1A 250V time lag.
Connections
EMS-96-ETH with all I/O and COM ports terminal boards.
EMS-96 or EMS-96H with all I/O, COM port terminal boards
and profibus port.
ETHERNET PORT
COM PORTS
8-
8+
7-
7+
6-
6+
5-
5+
Do
3-
3+
4-
4+
4+
4-
3+
3-
2+
2-
1+
1-
I/O
N
VL3
VL2
VL1
I3
I2
I1
S2
S1
S1
S2
S2
S1
S2
S1
1-
1+
2-
2+
2
1
Do
Do
C
8-
8+
7-
7+
6-
6+
5-
5+
Do
3-
3+
4-
4+
4+
4-
3+
3-
2+
2-
1+
1-
I/O
N
VL3
VL2
VL1
I3
I2
I1
S2
S1
S1
S2
S2
S1
S2
S1
1-
1+
2-
2+
2
1
Do
Do