25
PC1000i Crimper – Operator Manual
PC1000i Crimper with CrimpIQ™ Controller
Selecting a Die
If a non-recommended die or no die is set, the controller will prompt the user with a list of configured dies. The CrimpIQ
™
controller will recommend a die that can crimp the required crimp diameter.
Once a die is selected, the machine will prompt the user to confirm/install the die in Change Die mode (described above).
Notes:
• Dies that are grayed out are excluded because they are not capable of reaching the crimp diameter.
• This list is scrollable. You can slide the list up and down but, in general, the list will be centered on the dies that can be used
for this crimp.
• This list is limited to the dies configured when the initial machine setup was completed
(either in the factory or during the initial machine setup).
• If you have a die appropriate for this crimp but it is not in the list of dies, you can manually
enter this die by choosing the Enter Manual Die option on the bottom right.
• If the selected die cannot crimp to the required crimp diameter, the crimper will display a warning.
Beginning a Crimp