17
W415-0318 / 03.05.09
7.0 ADJUSTMENTS
7.1 VENT
RESTRICTION
6.0.4
Disconnect the two blower wires. Remove the
blower bracket secured with one wing nut and
lock washer. For thermodisc replacement:
Remove the "Z" shaped mounting bracket
secured to the fi rebox wall behind the left side
control door. Remove the thermodisc from the
bracket and replace.
6.0.5
Replace the blower using the existing bracket. Slide
the vibration reducing pad (A) into the clip (C) and
up against the threaded stud (B) at the other end.
The blower must be able to be positioned entirely
onto the pad.
Slide the blower into the clip (C). Secure to the
threaded stud using the existing lock washer and
wing nut. Ensure that the blower does not touch the
fi replace base or the fi rebox.
6.0.6
Reconnect the two wires. Holding the replacement
gasket in place, re-attach the blower access door.
Replace the backwall, logs and log support.
Reinstall the fi re viewing door.
6.0.7
Turn the gas supply and electricity back on.
Drywall dust will penetrate into the blower
bearings causing irreparable damage and must
be prevented from coming into contact with the
blower or its compartment. Any damage resulting
from this condition is not covered by the warranty
policy.
a
b
C
THERMODISC BRACKET
ASSEMBLY
BLOWER WIRES
BLOWER THROUGH ACCESS DOOR
Vertical terminations running longer than fi fteen feet may display a
very active fl ame. When this is not desirable, a vent restrictor could
be installed. This restrictor plate will reduce the velocity of the exhaust
gases, slowing down the fl ame pattern and creating a more traditional
appearance.
7.1.1
Remove the glass viewing door and logs.
7.1.2
Secure the restrictor plate as described.
7.1.3
Replace logs and viewing door.
Line up the holes on the vent restrictor with the holes on the bracket
attached to the roof of the fi rebox.
Secure the vent restrictor into position using the two screws supplied.
FIGURE 6.0.4b
FIGURE 6.0.5a
FIGURE 6.0.5b
FIGURE 7.1a
FIGURE 7.1b
FIGURE 6.0.4a
B
A
