37
W415-1283 / F / 04.30.18
finishing
EN
main door removal / installation
A.
Remove the safety barrier, see "main safety barrier removal / installation" section.
B.
Loosen but do not remove the three securing screws from the top retainer and pull retainer away from the
appliance, refer to Figure 1.
C.
There are two latches on the top of each door, refer to Figure 2. Using the tool provided, pull the latch
forward and upwards, out of the slot in the door, as shown.
Ensure to keep one hand on the door at
all times, to prevent it from falling on the floor.
D.
When both latches have been released, tilt the door forward and out of the bottom door retainer.
E.
Reverse this process to install the door.
FIG. 1
FIG. 2
LATCHES
IMPORTANT: Once latches are engaged,
test that the door is secure and will not
fall forward before letting go.
• Glass may be hot. Do not touch glass until cooled.
• If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
• Facing and/or finishing materials must not interfere with air flow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
• Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
!
WARNING
