User’s Manual
10
5. Release the reset switch. All of the DVR’s settings are now at the original settings it
had when it left the factory.
Connecting the Power Cord
Figure 19 — Power cord connector.
Connect the AC power cord to the DVR and then to a wall outlet.
CAUTION: The power cord must be connected to the DVR before it is connected
to a wall outlet, otherwise, the DVR might NOT be powered up properly. If the
DVR is not turned on after connecting the power cord, disconnect the power
cord, wait 10 seconds, and restart the DVR by following the proper connection
procedures.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING
HAZARD. MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR
ABRADED BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS
OR CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES
NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG.
DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO
ONE CIRCUIT.
Your DVR is now ready to operate. Refer to
Chapter 3 — Configuration
and
Chapter 4 —
Operation
.
Summary of Contents for CADV-H-XD16
Page 2: ......
Page 3: ......
Page 13: ...User s Manual x...
Page 111: ...User s Manual 98...