2. Setup
AD12-16(PCI)E, AD12-16U(PCI)E, AD16-16(PCI)E
33
Step 5 Checking Operations with the Diagnosis
Program
Use the diagnosis program to check that the board and driver software work normally, thereby you can
confirm that they have been set up correctly.
What is the Diagnosis Program?
The diagnosis program diagnoses the states of the board and driver software.
It can also be used as a simple checker when an external device is actually connected.
Using the “Diagnosis Report” feature reports the driver settings, the presence or absence of the board,
I/O status, and interrupt status.
Check Method
To check analog I/O data, connect the signal.
The diagrams below show examples of using channel 0 on the AD12-16(PCI)E. For details on the
connections, see Chapter 3 “External Connection”. Check the board with the factory defaults
untouched.
Wiring Diagram
<Analog input>
Analog Ground
(CN1)20pin
CH0
(CN1)1pin
- Single-Ended Input
Board
Signal source
(e.g.Battery etc.)
(CN1)2pin
CH0-
Analog Ground
(CN1)20pin
CH0+
(CN1)1pin
- Differential Input
Board
Signal source
(e.g.Battery etc.)
CAUTION
-
To check the analog input in differential input mode, set the jumpers to change the input mode setting
in advance. For details, see “Setting the Analog Input” in this chapter.
-
Input data remains indeterminate when no input pin is connected. The input pin for the channel
not connected to the signal source must be connected to the analog ground. For details, see
“Chapter 3 External Connection”.
<Analog output>
Board
e.g.Tester
Analog Ground
(CN1)20pin
CH0
(CN1)17pin
Figure 2.16. Wiring Diagram
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
