Contec BX-100n-DC5000-C01, User Manual, Page: 25 / 145

3. Hardware Setup
18
BX-100n User’s manual
Hardware Setup
- Before you start, be sure that the power is turned off.
- Remove only those screws that are explained. Do not move any other screw.
Attaching the CF Attachment Fittings
(1) After inserting a CF Card, fasten the bundled CF attachment fittings with a screw.
Figure 3.1. Attaching the CF Attachment Fittings
CAUTION
- Insert the CF Card face up.
- Screw holes may be damaged if screws are tightened with a torque greater than the specified
torque.The specified tightening torque is 3 - 3.5kgf
⋅
cm.
Attaching the Attachment Fittings
(1) Use screws to attach the bundled attachment fittings with a screw.
Do not tighten screws with excess force.
BX-100n-DC5xxx-C01 BX-100n-DC5xxx-C02
* Attached screw (M3 x 8)
Figure 3.2. Attaching the Attachment Fittings
CAUTION
Screw holes may be damaged if screws are tightened with a torque greater than the specified torque.
The specified tightening torque is 5 - 6kgf
⋅
cm.