TDMA CONTROL 602-702 Eng Nov.doc
39
Output View?
By confirming with the outputs appear as follows:
View of CONTROL 602:
1
3
5
7
M 1 : 00,0 V
2
4
6
8
M 2 : 00,0 V
With the CONTROL 702 the outputs are shown in two views (View 1 = output
1 to 19, View 2 = Output M1 to M6).
If an output is switched on the corresponding number will change to a
,
whilst for unswitched outputs the display shows a
symbol. The outputs that
require a 0-10V voltage are displayed along side the corresponding M
symbol. With pressing the key you will be returned to the service menu.
Select Language
English
The language used can be selected here from English, German, French and
Italian.
Authorisation:
Set?
The professional menu can be access by using the code number 3003.
30 minutes after the last input, the controller automatically locks the
professional menu.
By inputing 0000, the professional menu is locked..
5.12
Software Update via SD-Card
Note:
A software update is only possible in the professional menu.
Any new controller software must be stored on the SD Card under a folder
called ‘Firmware”. This allows the controller to locate the software.
The settings made in the web portal such as data recording, graphical views,
may need to be re-set after a firmware update. It is recommended that the
data is saved prior to the update.
Authorisation:
Set?
The Engineer’s menu is found by inputing the cose 3003 in the authorised to
set option.
Insert the SD-Card into the slot provided on the side of the controller (see
photo). When the controller detects the SD Card, an SD Card icon appears in
the display window.
Located on the SD Card in the ‘Firmware’ folder is a control software that
matches the controller, the controller asks whether a software update is to be
performed.
