8
2 person assembly is required to build any Co.Table configuration.
3,990mm diner table assembly
For 2,600mm diner table assembly, please proceed to page 1.
Components
• 3,990mm metal underframe
• 4x diner table legs
• 2x end laminate table tops (these could
be D-end or square ends depending on
product order)
• 1x central laminate table top
• 2x utility rail end caps
• 2x utility rail end cap brackets
• 3x large utility rail brackets
• 3x small utility rail brackets
• 3x under panels
• 16x under panel brackets
If your Co.Table includes a poseur table, proceed
to steps 1-11 on page 14 once completing
this section.
Fixing Kit
Your 3,990mm Co.Table fixing kit will consist of
the following:
• M6 x 16 furniture bolt
• Wooden biscuit
• Double pins
• Cam covers
• M8 x 50 socket head
• M8 x 30 washer
• M4 square nut
• M4 x 12 button head
• 10x 5/8 self tap
• 12 x 1” Pozi selftap CSK screws
• M6 x 8 button head
Building the frame and adding legs
1.
Unwrap 3,990mm metal underframe and place in space close to where the table will situate.
There are corners of the metal underframe removed to allow for table legs to be attached
2.
Screws to connect legs to metal underframe can be found already attached to the legs. Note
that all legs will allow for power to run down
3.
Remove screws from leg, face leg up to outside corner of the metal underframe and reattach
the screws by threading through the inside of the frame and back into the leg. Initially screw
loosely. Note: It may be easier to connect legs with frame on its back and wooden legs in the air
1
2
3
Assembly Instructions
Co.Table
