14
Adding the poseur end
This is additional to the previous diner table assembly instructions. Ensure diner table build is
complete before starting poseur table build. Components below will be included in original delivery.
Components
• Square poseur metal underframe
• 2x poseur short legs
• 2x poseur long legs
• Laminated poseur table top
• 1x under panel
• 4x under panel brackets
Building the frame and
adding legs
1.
Corners of the poseur metal
underframe are removed
to allow for table legs to be
attached
2.
Screws to connect both sets
of legs to metal underframe
can be found already
attached to both large and
short legs
3.
Remove screws from leg,
face leg up to outside corner
of the metal underframe
and reattach the screws by
threading through the inside
of the frame and back into the
leg. Initially screw loosely Note:
It may be easier to connect
legs with frame on its back and
wooden legs in the air
4.
Repeat step 3 four times until
all legs are loosely attached.
Ensure that short legs are
both on one side and large
legs are both on one side.
Keep the legs loosely screwed
together until attached to
diner table
Connecting frame to table
5.
Square end of diner table will
have pre-cut holes underneath
the table but not showing
through table top. These will
need to be drilled through
carefully, so holes now come
through table
6.
Position the shorter legs
attached to poseur table
frame on top of diner table
and position over the top of
through holes
1
3
2
5
6
Assembly Instructions
Co.Table
