12
17
17.
Once lamp has been inserted into utility rail and cable thread through, reattach metal plate by
sliding in place. Tighten nut to secure the lamp in place. This will need repeating for each
1
8
.
Multiple Co.Table Lamps will need to be connected to a distributor block to allow for cables to
run out of table. A 2.0m extension cable will be provided to connect Co.Table lamp cable to
distributor block. Once both are connected to a distributor block, a 5.0m extension cable will be
connected to allow cable to run out of table.
18
Please note that light bulbs will not be included.
19.
Each laminate table top will come with a hole cut out as
standard. These allow for power to run from the power rail
through the table. Position the utility rail onto the table, with
the power brackets central over these holes
14
19
Note: Following imagery shows utility rail brackets attached without power. This is for ease of
imagery. Please connect brackets once power has been connected to utility rail.
20.
Two sizes of utility brackets will be used. The Small utility rail bracket with only 2 cut outs will be used
within the utility rail. The larger utility rail bracket will be used on the underside of the table tops
21.
Position the small utility rail bracket over the cut out in the table tops, with the ends sitting on
top of the utility rail. Make sure that power cut outs and power brackets in utility rail are central
20
21
Assembly Instructions
Co.Table
