Condair US 13, Operation And Maintenance Manual

Page: 33 / 74

6.2.8 Changing Your Settings
This section shows a brief overview of available settings and where to go to change them.
Do not forget to press
enter
to save your change.
I want to...
6.2.8.1 Change the period between flushing cycles.
(refer to
"Flush Cycle A/B" on page 29
)
Main Menu > Configuration > Features > Flush Cycle A/B
6.2.8.2 Activate the Ultrasonic Blower Pack.
(refer to "Blower Pack A/B" on page 29 )
Main Menu > Configuration > Features > Blower Pack A/B
6.2.8.3 Change how the large humidifier reacts to demand.
In parallel, series, or independently (refer to "Dual Humidifier Mode" on page 30 ).
Main Menu > Configuration > Control Settings > Dual Humidifier Mode
Note: For dual reservoir units only.
6.2.8.4 Use the humidifier at X% capacity. To set up and configure the
manual capacity control type.
(refer to "Control Configuration" on page 30 and "Manual Capacity" on page 30 )
1)
Go to
Main Menu > Configuration > Control Settings > Humidifier A/B* >
Control Configuration > Manual Capacity
2)
Return to previous menu then,
Control Settings > Humidifier A/B* > Manual
Capacity
Note: *For dual reservoir units only. Single units: Configuration > Control Settings > Control Configuration.
6.2.8.5 Humidify the space at X% setpoint, based on a control signal.
To set up and configure the humidity control (refer to
"Control Channel 1/2" on page 30
).
1)
Go to
Main Menu > Configuration > Control Settings > Humidifier A/B* >
Control Configuration > Single Channel (or) Dual Channel
2)
Return to previous menu then select a channel,
Control Settings > Humidifier
A/B* > Channel 1 (or) Channel 2
3) Input the Setpoint Control Mode, Signal Type, Bandwidth, and I-Time.
Note: *For dual reservoir units only. Single units: Configuration > Control Settings > Control Configuration.
6.2.8.6 Put the humidifier on standby.
(refer to "Control Settings" on page 29 )
Set the demand to 0%.
US
2588787_B_EN_2005_US_OM
User Interface | 33