20
Operation
Condair TE
5.10
Factory Reset the Remote controller (to default)
Reset the remote controller to its default settings.
To reset the remote controller:
1. Turn off the humidifier and confirm that the power light is off on the remote controller.
2. Press and hold the side button on the remote controller for 10 seconds.
The power light (green), humidification light (green), and high fan light (orange) will illuminate simul
-
taneously for 3 seconds, then the remote controller will power off.
Default settings for the humidifier cannot be reset automatically, as they would be set physically with
wires or DIP switches. To restore the humidifier to it’s default settings, turn all of the DIP switch pins to
the OFF position. Refer to the installation manual to reconfigure the initial signal input/outputs.
5.10.1
Default Settings (Remote Controller)
Table 9: Default settings
Light
Setup
Power
○
Humid.
-
High
-
Low
-
Humidity level detection using the humidistat built into the remote controller.
Drying mode
-
No interlocking operation with external equipment.
Error
-
Humidity detection sensitivity set to high.
Humidity setpoint 40% RH
