Concoa Advantium 16, Installation And Operating Instructions Manual, Page: 5 / 28

3
UNDERSTANDING ALARM OPERATION
Figure 1
Figure 1 shows the location of the various inputs, outputs and indicators for the
Advantium 16. The Advantium 16 has a universal power supply.
Input signals coming from external devices are connected to the Advantium 16 via
individual wires through a ¾” conduit connection to a terminal strip.
The Advantium 16 provides output relay signals to indicate the state of 18 user defined
alarms . These signals are brought out through relay contacts terminal connector. The
relay contacts terminal section consists of 9 terminal blocks. Each terminal block
contains two relay output signals and a shared common voltage input. The Advantium 16
is factory set so that these output signals are brought out through Normally Closed (N.C.)
contacts.
Output relay signals are routed from the Advantium 16’s terminal strip via individual
wires through a ¾” conduit connection on the left side.
These contacts can be changed, if needed, to Normally Open. Refer to the section in this
manual “Changing Output Relay Contacts”.
Figure 1 shows a view of the front panel. It is laid out with sixteen status lights
representing 16 signal inputs. The indicator lights are bi-colored LEDs. This means that
the same light can be turned ON as either a green indicator or a red indicator. A green
LED indicates a normal condition while a red LED indicates an alarm condition. A