11
SETTING REMOTE ALARM OUTPUTS
The output signals from the
Advantium
16 are brought out of the alarm through relay
contacts. These contacts are set as Normally Closed (N.C.) FACTORY DEFAULT. The
relay contacts can be reconfigured as Normally Open (N.O.). To change the relay
configuration perform the following steps:
1.
Unplug the alarm from AC power.
2.
Open the unit by loosening the 6 screws located on the front of the enclosure.
3.
Figure 11 shows the location of the jumpers on the circuit board for setting the
contacts.
4.
Using Table 1 and Figure 11 set the jumpers to the desired contact arrangement.
5.
Reattach the two sections of the enclosure with the screws previously removed.
6.
Make the necessary connections to the alarm and plug the alarm cable into the
alarm connector on the bottom of the cabinet.
7.
Plug the alarm back into the AC power.
Figure 11
Summary of Contents for Advantium 16
Page 7: ...5 MOUNTING REQUIREMENTS Figure 2...
Page 9: ...7 Figure 4...
Page 11: ...9 Figure 9...
Page 27: ...25...