Comtech EF Data CDD-880, Installation And Operation Manual

Page: 124 / 234

CDD-880 Multi Receiver Router MN-CDD880
Serial-based Remote Product Management Revision 2
7–8
• Target-to-Controller: This is the two-character sequence ‘Carriage Return’, ‘Line Feed’ ([cr][lf]) (ASCII codes 13 and 10). Both indicate
the valid termination of a packet.
7.3 Remote Commands and Queries
NOTES:
1) Index Columns – Where Column ‘C’ = Command, and Column ‘Q’ = Query, columns marked ‘ X ’ designate the instruction code as
Command only
,
Query only
, or
Command or Query
.
2)
= Message ok
In the tables that follow, these codes are used in the ‘Response to Command’ column (per Sect. 7.2.2.5.2):
# Message ok, but unit is not in Remote mode.
? Received ok, but invalid arguments were found. ! Invalid instruction.
^ Message ok, but unit is in Ethernet mode.
INSTRUCTION CODE USED TO... C Q Page
DPW Set default passwords X 7-9
IG1
Set or query the IP Address and network prefix for the 10/100/1000 BaseT GigE ETHERNET |
TRAFFIC | GE port
X X
7-9
IPA
Set or query the IP Address and network prefix for the 10/100/1000 BaseT GigE ETHERNET |
TRAFFIC/MANAGEMENT | GE port
X X
7-9
LC1 Set or query the link configuration for the 10/100/1000 BaseT GigE ETHERNET | TRAFFIC | GE port X X 7-9
MAC Query the unique router MAC Address
X
7-9
MG1 Query the unique 10/100/1000 BaseT GigE ETHERNET | TRAFFIC | GE port MAC Address X 7-10
MLC
Set or query the link configuration for the 10/100/1000 BaseT GigE ETHERNET | TRAFFIC | GE and
ETHERNET | TRAFFIC/MANAGEMENT | GE ports
X X
7-10
NPS
Query the negotiated port speeds for the 10/100/1000 BaseT GigE ETHERNET | TRAFFIC | GE and
ETHERNET | TRAFFIC/MANAGEMENT | GE ports
X
7-10
SRC Set or query the SNMP Read Community String
X X
7-10
SWC Set or Query the SNMP Write Community String
X X
7-10