Comtech EF Data CDD-880, Installation And Operation Manual

Page: 121 / 234

CDD-880 Multi Receiver Router MN-CDD880
Serial-based Remote Product Management Revision 2
7–5
The ‘ < ’ and ‘ > ’ characters indicate the start of packet. They may not appear anywhere else within the body of the message.
7.2.2.2 Target Address
In EIA-232 applications, this value is set to 0000 .
The Target Address designates the packet destination. The Controller does not have its own address. After the Controller
sends a packet with the designated Target Address, the Target responds to the Controller, using this same address, to
indicate the source of the packet.
7.2.2.3 Address Delimiter
This is the “forward slash” character ' / ' (ASCII code 47).
7.2.2.4 Instruction Code
This is a three-character alphanumeric sequence that identifies the message subject. Uppercase alphabetic characters (‘ A ’ to ‘ Z ’, ASCII
Codes 65 to 90) and the numbers ‘ 0 ’ to ‘ 9 ’ *ASCII Codes 48 to 57) may be used. Wherever possible, each instruction code is named to
serve as a mnemonic for its intended operation. This helps you interpret the code function, should it be shown in its raw ASCII form.
For example: MLC for M anagement L ink C onfiguration, IPA for Management IP A ddress, etc.
7.2.2.5 Instruction Code Qualifier
This is a single character that further qualifies the preceding instruction code.
7.2.2.5.1 Controller-to-Target Instruction Code Qualifiers
The only permitted characters are ‘ = ’ and ‘?’.
= (ASCII Code 61)