Comtech EF Data CDD-562AL, Installation And Operation Manual

Page: 155 / 244

CDD-562AL/564A/L Multi-Channel Demodulator Revision 0
Telnet and CLI Operation MN-CDD562AL564AL
9–49
•
Packets are filtered because an Off-line modem is receiving packets from WAN port.
Filtered – Unknown Reason Code
•
Packets dropping because of reasons unknown
Filtered – Flow Correlator
•
Packets are filtered because of incorrect establishment of SAT-to-SAT traffic. This counter is
seen typically on the out-bounding Hub modem in point-to-multipoint setup.
Filtered – Management Path
•
Not used.
Filtered – WAN Scaling
•
Internal Error occurred during WAN scaling sub process in processing packet.
Filtered – Ping
•
Ping packets were received but PING feature was disabled.
Filtered – Access Control
•
Packets are received while “Access List” control is enabled but IP address does not match the
access list database.
Filtered – Vipersat MCP
•
Internal Error occurred while processing Vipersat Multi command messages.
Filtered – Vipersat UCP
•
Internal Error occurred while processing Vipersat Uni-command messages.
Filtered – Codeload
•
Internal error occurred while processing Codeload messages.
Filtered – Multicast
•
A multicast packet is received but there is no application associated with it.
Filtered – Bad Packet
•
Malformed packet is received. This may be due to internal or external error.
Filtered – Route
•
Applies to Vipersat Remote only – when a packet is received from the WAN and the Route Table
contains a route to transmit that packet to the WAN, the packet will be filtered to prevent a
routing loop.
Filtered – Vipersat Remote
•
Packet filtered due to QoS Rule configured to filter.
Filtered – QoS Rule
•
Packet filtered due to QoS Rule configured to filter.
Filtered – Vipersat Loop
•
Packet filtered due to Vipersat loop (a modem configured as a Vipersat Remote Expansion unit
and default route set to 0.0.0.0/0).