Comprag 11100061, Manual

Page: 28 / 88

+7 (800) 777-83-75(звонок бесплатный)
www.v-p-k.ru A3008
and the 2 corresponding nuts on the tensioner. Tighten the 4 screws of the bracket of the
air end. Check the belt tension within four hours of the
compressor’s operation in accor-
dance with section 5.3 .
5.7 Changing air-oil separator
The separating component (1) is
located within the separator tank.
Open the front panel in order to
change it. Unscrew the bolts (2) and
carefully remove the top cap of the
tank. Disconnect hoses if they make
it difficult to remove the cap. Remove
the spent separator and install a
new one in its place. Refasten the
tank cap
.
Fig. 5.7 Changing air-oil separator
5.8 Cleaning radiator
In order to access the radiator (1),
open the front or right panel.
Regularly clean the radiator in order
to maintain its cooling efficiency at an
acceptable level.
Remove any dirt particles from the ra-
diator using a fibre brush, then aim a
jet of compressed air at the radiator
from the bottom to the top; the jet
should be held at an approximate
90° angle to the plane of the radia-
tor.
Fig. 5.8 Cleaning radiator
28