comPPage PIA3264, Manual

Page: 13 / 38

Paging Interface Adapter
13
Paging Protocol
1. Select the paging protocol of the paging encoder installed.
a. Scope
™
b. Motorola Comp2
™
c. WaveWare
™
d. Motorola TAP V1.8
™
Communications Port Parameters
This setting must match the port settings of the paging encoder installed.
1. 9600 n-8-1
2. 9600 e-7-1
3. 2400 n-8-1
4. 2400 e-7-1
5. 1200 n-8-1
6. 1200 e-7-1
Total Number of Contacts
Each PIA3264 has a capacity for 64 inputs. This selection is where you will enter how many inputs
are installed in the unit you are programming. (maximum of 64)
1. Master with 64 inputs – Enter 64
2. Master with Slave attached – Enter 64
3. The Master will know which contacts are on the Slave and which are on the Master.
Example: Master with 64 inputs and 1 slave attached with 16 inputs. On the Contact
Programming screen you would program the first 64 contacts with the information of
the inputs connected to the master. The next 16 contacts (65-80) you would program for
the information of the inputs connected to the Slave.
Monitoring Pagers
This option has two global pager IDs that can be identified so all alarm notification will be
sent to the Monitoring Pagers, as well as other pager IDs that are for specific alarms.
1. Enter Pager Cap Codes and Alert type [A,B,C or D].
Note: This option is not available when using Non-Voltage (Dry) input.
System OK Check
This selection allows the user to select a pager ID and time interval for the system to transmit a
SYSTEM OK check-in message.
1. Enter Pager ID. (after the screen has refreshed the leading zero will not be displayed, this is
Normal)
2. Enter Alert Type
3. Select the time interval.