Paging Interface Adapter
11
RS485 Installation
If installing a Master PIA3264R2 and additional Slave units, each unit must have a different IP address.
However, the IP addresses must be in the same number sequence.
Changing PIA3264 IP Address on the Master or Slave
If the default IP address on the PIA3264 needs to be changed, you need to access it from the Internet
browser screen and assign a new IP address. You must log on to the PIA3264 to change the IP address.
1.
Connect the PIA to a stand alone PC using the supplied RJ45 Cross Over cable.
2.
Apply power to the PIA and turn on unit, the
GREEN
power light will illuminate
.
3. On the PC Internet Explorer Browser address line, enter the Paging Interface Adapter IP
address. [
192.168.1.239
]
4. When the log on screen appears, enter your log on information.
5. The following screen will appear.
7.
On the Global Setting page, in the space next to the IP Address, enter the new IP
address you want the unit to have. Be sure to record the new IP address some where, if you
forget it there is no way to access the PIA3264 once you log off. If no Slave Units are going to
be connected, disregard the IP Address after Unit ID.
8.
After entering the new IP address, go to the bottom of the page and click on
Save Database
.
This will write the new address to memory.
You
MUST
cycle the power on the PIA3264 before the new IP address will be effective
Summary of Contents for PIA3264
