Compliance West HT-2000PR, Instruction Manual

Page: 18 / 41

12
Section 3
Operation
This section describes how to set up and make measurements with your tester. We recommend
that you read the entire section carefully so that you can use all of the features of your tester.
Setting up your Tester
Your tester is shipped in a special protective container that should prevent damage to the
instrument during shipping. Check the shipping order against the contents of the container and
report any damage or incomplete shipment to Compliance West USA. The container should
include the following:
-
The HT-PR Dielectric Withstand Tester
- An 18 AWG Test Lead (Alligator Clip/Banana Plug ends, black)
- An 18 AWG Line Power Cord to provide power to the HT-PR
- This Instruction Manual
If reshipment of the instrument is necessary, please use the original shipping container. If the
original shipping container is not available, be sure that adequate protection is provided to
prevent damage during shipment. We recommend that the instrument be surrounded by at least
three inches of shock-absorbing material on all sides of the container.
Remove the tester from its container and place it on a test bench.
Return Test Lead Power cord
Table 2. Included cables
AC Line Voltage Requirements
AC line voltage requirements for your Tester are noted on the rear panel of the instrument. Do
not connect the instrument to a different voltage source, use the power cord and make sure you
have a ground connection in your building before you start testing.