Compaq TruCluster Server AA-RHGWB-TE, Manual

Page: 103 / 320

For use with the MC2 CCMAB adapter, the hub must be placed within
4 or 10 meters (the length of the BN39B link cables) of each system. If
fiber optics is used in conjunction with the MC2 adapter, the hub may be
placed up to 31 meters from the systems.
• Ensure that the voltage selection switch on the back of the hub is set to
select the correct voltage for your location (115V or 230V).
• Ensure that the hub contains a linecard for each system in the cluster
(the hub comes with four linecards) as follows:
– CCMLA linecards for the CCMHA MC1 hub
– CCMLB linecards for the CCMHB MC2 hub. Note that the linecards
cannot be installed in the
opto only
slot.
• If you have a four-node cluster, you may want to install an extra linecard
for troubleshooting use.
• If you have an eight-node cluster, all linecards must be installed in the
same hub.
• For MC2, if fiber optics converters are used, they can only be installed in
hub slots
opto only
,
0/opto
,
1/opto
,
2/opto
, and
3/opto
.
• If you have a five-node or greater MC2 cluster using fiber optics, you
will need two or three CCMHB hubs, depending on the number of fiber
optics connections. You will need one hub for the CCMLB linecards (and
possible optics converters) and up to two hubs for the CCMFB optics
converter modules. The CCMHB-BA hub has no linecards.
5.5 Installing the Memory Channel Cables
Memory Channel cable installation depends on the Memory Channel module
revision, and whether or not you are using fiber optics. The following sections
describe how to install the Memory Channel cables for MC1 and MC2.
5.5.1 Installing the MC1 or MC1.5 Cables
To set up an MC1 or MC1.5 interconnect, use the BC12N-10 10-meter
link cables to connect Memory Channel adapters and, optionally, Memory
Channel hubs.
______________________ Note _______________________
Do not connect an MC1 or MC1.5 link cable to an MC2 module.
Setting Up the Memory Channel Cluster Interconnect 5–7