Compaq TruCluster Server AA-RHGWB-TE, Manual

Page: 212 / 320

12. Press and release the up or down button and the SELECT button
simultaneously, and verify that System On-line or System Off-line is
displayed in the SDA.
To set the SCSI ID for each tape drive if the desired SCSI IDs are different
from those shown in Table 8–4, follow these steps:
1. Press and release the Control Panel STANDBY button and verify that
the SDA (Status Display Area) shows System Off-line.
2. Press and release SELECT to enter the menu mode.
3. Verify that the following information is displayed in the SDA:
Menu:
Configuration:
4. Press and release SELECT to choose the Configuration menu.
5. Verify that the following information is displayed in the SDA:
Menu: Configuration
SCSI Address
6. Press and release the SELECT button again to choose SCSI Address
and verify that the following information is shown in the SDA:
Menu: SCSI Address
Robotics
7. Use the down arrow button to bypass the Robotics submenu and verify
that the following information is shown in the SDA:
Menu: SCSI Address
Drive 0
8. Use the up and down arrow buttons to select the drive number to set
or change.
9. When you have the proper drive number displayed on line 2, press and
release the SELECT button and verify that the following information is
shown in the SDA:
Menu: Drive 0
SCSI ID 0
10. Use the up and down arrow buttons to select the desired SCSI ID for
the selected drive.
11. When the desired SCSI ID is displayed on line 2, press and release
the SELECT button.
12. Repeat steps 8 through 11 to set or change all other tape drive SCSI IDs.
13. Press and release the up or down button to clear the resulting display
from the command.
8–32 Configuring a Shared SCSI Bus for Tape Drive Use