Removal and Replacement Procedures
NAS B2000 Maintenance and Service Guide
2-23
COMPAQ CONFIDENTIAL
Codename: Collins Part Number: 292280-001 Last Saved On: 5/30/02 11:58 AM
Non-Hot-Plug Procedures
You must power down the NAS B2000 to perform non-hot-plug removal and replacement
procedures. The components in this section are non-hot-plug service items, regardless of rack
type or environment.
Front Bezel and Faceplate
To remove the front bezel and faceplate:
1.
Power down the device. See the “Powering Down the Device” section in this chapter.
2.
Extend or remove the device from the rack. See the “Preparation Procedures” section in
this chapter.
3.
Remove the access panel. See the “Access Panel” section in this chapter.
4.
Remove any hot-plug SCSI hard drives, if installed. See the “Hot-Plug SCSI Hard Drive”
section in this chapter.
5.
Remove any hard drive blanks, if installed. See the “Hard Drive Blank” section in this
chapter.
6.
Remove the tape drive, if installed. See the “Universal Hot-Plug Tape Drive” section in
this chapter.
7.
Use a Torx T-15 screwdriver to remove the four bezel screws.
8.
Tilt the top of the bezel downward.
9.
Remove the bezel.
10.
Remove the faceplate.
2
1
1
1
3
4
Figure 2-21: Removing the front bezel and faceplate
Reverse steps 1 through 10 to replace the front bezel and faceplate.
