Removal and Replacement Procedures
2-10
NAS B2000 Maintenance and Service Guide
COMPAQ CONFIDENTIAL
Codename: Collins Part Number: 292280-001 Last Saved On: 5/30/02 11:58 AM
Tape Drive Blank
To remove the tape drive blank:
1.
Remove the hot-plug SCSI hard drive or hard drive blank in the bay below the tape drive
blank:
•
If a hot-plug SCSI hard drive is installed in the bay, see the “Hot-Plug SCSI Hard
Drive” section in this chapter.
•
If a hard drive blank is installed in the bay, see the “Hard Drive Blank” section in this
chapter.
2.
Squeeze the middle of the tape drive blank.
3.
Pull to remove the blank.
1
2
Figure 2-6: Removing the tape drive blank
CAUTION:
Always populate the tape drive bay with either a tape drive or hard
drive blank and tape drive blank. Operating the device without installing a tape
drive or blank results in improper airflow and improper cooling that can lead to
thermal damage.
To replace the tape drive blank, slide the blank into the bay until it locks into place.
