Rack-Mountable Server Installation
2-19
Compaq Confidential – Need to Know Required
Writer:
Gilbert Saldivar
Project:
Compaq ProLiant 6400R Setup and Installation Guide
Comments:
Part Number:
388776-002
File Name:
c-ch02 Rack-Mountable Server Installation
Last Saved On:
3/17/00 1:41 PM
WARNING:
To reduce the risk of personal injury or damage to the equipment, a
minimum of two people must lift the server onto the slide rails. The Compaq
ProLiant 6400R server can weigh up to 75 lb (34 kg).
3.
Align the server screw holes with the slide rail screw holes.
Figure 2-10. Loading the server with handles into the rack
4.
Attach the server to the slide rails with three screws on each side. Begin
with the back screw hole, and then adjust the inner slide rail and server
together to access the other screw holes through the slotted opening in
the inner slide.
5.
Remove the handles from the server.
IMPORTANT:
The first time you slide the server into the rack, you may have to apply
some pressure. After the first time, the ball bearings in the slide will move easily.
6.
Slide the server into the rack.
WARNING:
To reduce the risk of personal injury, be careful when pressing the
server rail release latches and sliding the server into the rack. The slide rails can
pinch your fingertips.
7.
Press the server rail release latch on either side of the server, and
continue to slide the server into the rack.
IMPORTANT:
When servicing the server, fully extend the server until the latches lock. To
return the server to the rack, press the latches and slide the server into the rack.
