7-2
Compaq ProLiant 6400R Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer:
Gilbert Saldivar
Project:
Compaq ProLiant 6400R Setup and Installation Guide
Comments:
Part Number:
388776-002
File Name:
h-ch07 Server Configuration and Utilities
Last Saved On:
3/17/00 1:41 PM
Installing the SmartStart and Support Software CD
1.
With the server turned on, locate the CD-ROM drive.
2.
Open the CD-ROM drive tray by pressing the Load/Unload button on
the front panel of the drive.
3.
Place the SmartStart and Support Software CD in the tray, handling it by
its edges, not by the flat surfaces of the disk.
4.
Close the tray by pressing the drive tray back into the CD drive.
Opening the Internal CD-ROM Tray Manually
If the CD-ROM tray does not open automatically, you can open it manually by
using the emergency Load/Unload button.
CAUTION:
Before beginning this procedure, place the server in Standby mode.
NOTE:
Certain applications or operating system software may disable the Load/Unload
button to prevent accidental damage to the disk. If the Load/Unload button is disabled by
the application software, it does not operate.
1.
Insert a metal rod, such as a straightened paper clip, into the manual
effect hole and push firmly. The tray releases.
2.
Slowly pull the tray out from the drive until the tray is fully extended,
then remove the disk.
To configure the server and load the operating system, refer to the SmartStart
documentation provided in the Server Setup and Management pack that
shipped with your server.
To manage the system, refer to the Compaq Management CD provided in the
Server Setup and Management pack that shipped with your server.
