Ruckus ICX 7750 Switch Hardware Installation Guide
61
Part Number: 53-1003900-10
Managing the Ruckus ICX 7750
•
•
•
•
•
•
Hardware maintenance schedule
Ruckus ICX 7750 switch hardware components require minimal maintenance. Ruckus recommends cleaning the fiber-optic connectors
on a fiber-optic port and the connected fiber cable each time you disconnect the cable.
Replacing a copper or fiber-optic module
You can remove an SFP+, or QSFP+ transceiver from a slot and replace it with a new one while the Ruckus ICX 7750 is powered on and
running.
This section provides information about the following tasks:
•
Removing a copper or fiber-optic module
•
Cabling a fiber-optic module
•
Cleaning the fiber-optic connectors
Removing a copper or fiber-optic module
While removing a copper or fiber-optic module, be sure to wear an ESD wrist strap that is connected to ground.
Before removing a fiber-optic transceiver, have the following items available:
•
The protective covering that you removed from the fiber-optic transceiver port when you initially installed the module.
•
An ESD wrist strap with a plug for connection to the ESD connector on the router chassis.
CAUTION
The procedures in this chapter are for qualified service personnel.
CAUTION
For safety reasons, the ESD wrist strap should contain a series 1 megohm resistor.
DANGER
Laser radiation. Do not view directly with optical instruments. Class 1M laser products.
